久久久久久网,精品自拍视频,一本本久综合久久爱

BYD Forklift Electric Stacker Maintenance Company-

Based on the market application scenario, the key parameters, safety detection, and storage action flow of the product are first designed overall; then, for the hydraulic synchronization problem in the lifting system, specific design schemes are proposed from the mechanical structure and hydraulic system aspects; finally, the feasibility of the scheme is verified through prototype testing

Internal combustion forklift Internal combustion forklifts are generally driven by fuel engines, using fuels such as diesel, gasoline, liquefied petroleum gas or natural gas With the development of economy and the improvement of environmental protection and energy saving requirements, all-electric reach stackers are developing rapidly direct and convenient, and the maintenance performance is better than that of horizontal motors7MPa) to drive the lifting hydraulic cylinder and the tilting hydraulic cylinder 1

If the temperature is significantly lower than -15℃, the engine system cannot be operated immediately after starting, but the engine should be run at 1000-1100r/min for 10-15min, and the transmission should be in a neutral position

We must understand them clearly and make a good distinction when choosing

Whether purchasing an electric transport truck, an electric stacker or a manual hydraulic forklift, in addition to considering its own site, environment and other conditions as well as requirements for battery life, product quality, etc

In response to the above problems, the safety inspection plan proposed in this section is as follows: Loading device: ① It is designed with a pallet positioning device and a cargo size over-limit sensor, which will issue an alarm signal when the cargo width, length, or height exceeds the limit; ② It is designed with a cargo overweight sensor, which will issue an alarm signal when the cargo is overweight; ③ It is designed with a cargo position over-tolerance detection sensor and a sensor for judging the presence or absence of cargo

When the forklift is operating at the warehouse entrance or exit or indoors, it should slow down when driving on the uneven road surface or the inclined road surface (iron plate)

It also reduces the huge workload caused by labor costs

BYD Forklift Electric Stacker Maintenance Company-

When the chassis tilt exceeds the tolerance, the entire vehicle will issue an alarm signal and prohibit lifting operations

The fork deflection detection error shall not be higher than the maximum design deflection of the fork

Before and After Images In addition to forklift lifting, forklift reversing is also one of the largest blind spots, and forklifts are driven in reverse most of the time

The seals can be replaced

2M, 1

Nowadays, electric pallet trucks produced by electric transport truck manufacturers have become very common handling equipment in factories and warehouses

If you don't understand, you can also ask: Forklift manufacturer

There is a tortoise and rabbit regulator on the handle, and the tortoise speed and rabbit speed can be switched freely

Among them, the corrosive environment inside the forklift, such as the high temperature generated by the engine and the combustion exhaust gas containing sulfur and chloride ions, the acid mist and leakage generated by the battery, the stress generated by vibration and impact during operation, and the local damage caused by friction and collision are the main reasons for the corrosion damage of forklift parts

When using lifting equipment to lift a counterbalanced electric forklift, ensure that the lifting equipment is loaded with the required capacity

If the lifting height of the fork does not reach the required height, add hydraulic oil

When charging, unplug the power socket and connect the charger plug to the movable socket with a handle

Therefore, the competition among manufacturers in the current market is also fierce

BYD Forklift Electric Stacker Maintenance Company-

During normal use, pay attention to the insulation of the battery

The oil pump is excessively worn, causing internal leakage of the equipment, and needs to be replaced Impact of low temperature environment on hydraulic system Hydraulic oil used at room temperature is prone to freezing in low-temperature environments, requiring the viscosity of the hydraulic oil to be higher than that of ordinary hydraulic oil; in addition, hydraulic high-pressure hoses are also prone to fatigue, brittleness and hardening at low temperatures

In addition, by optimizing the control strategy, adjusting the start-up stability of the drive wheel and the followability during sharp turns, it is ensured that the forklift will not slip even when driving on a wet and slippery indoor ground, and avoid overturning during sharp turns, effectively ensuring the safety of the operator

In this case, we must pay attention to the battery temperature not being too low when charging the electric forklift in a low temperature area

There is a tortoise and rabbit adjuster on the handle, and the tortoise speed and rabbit speed can be switched freely

Lithium-ion batteries and lead-acid batteries are power batteries of two different systems, and the battery principles are also different

Before starting work every day, check the following safety features: ※ The speaker functions normally

have all laid out their layout in the forklift field

The new architecture and edge computing architecture generated by 5G will soon meet the low-time, high-speed operation, and rapid decision-making requirements of driverless cars However, as the country's environmental protection requirements continue to increase, the market demand for diesel forklifts will gradually decrease in the future

Flexible configuration of the forklift for subsequent use

It is very popular now because of its easy operation, time-saving and labor-saving

Forklift rental form In addition to long-term and short-term leases, forklift leasing also includes business package system (price calculated based on the amount of work done), project contracting system (price calculated based on the length of time the project is working), and lease-to-purchase system (after paying the rent on schedule for a longer period of time, the ownership of the forklift belongs to the lessee)

Counterbalanced forklift operators should try to avoid sudden stops and turns

New energy forklift leader

Product

BYD Counterbalanced forklift

BYD Warehouse Forklift

BYD large tonnage forklift

BYD tractor truck

Core Features

High security

high performance

High efficiency

High Match

Low overall cost

Super fast charging

Ultra-long life

No charging room required

About Us

Product

BYD Forklift

Contact Info